Seagate ST336704LW SCSI Hard Drive
Capacity: 36GB
Spindle Speed: 10,000RPM
Interface Type: SCSI 68pin / HD68 Female
Disk Size: 3.5″x1.0″ (LFF Hard Drive)
Sustained Throughput (MBps): 40
Average Seek Time (read/write ms): 5.4 / 6.2
Electrical Interface Speed: SCSI LVD U160 – 160MBps 16-bit
On-Board Cache: 8MB
The Cheetah 36LP family has the following standard features:
Integrated Ultra160 SCSI controller
Multimode SCSI drivers and receiverssingle-ended (SE) and low voltage differential (LVD)
16 bit I/O data bus
Asynchronous and synchronous data transfer protocol (supports Ultra160 transfer rate)
Firmware downloadable via SCSI interface
Selectable even byte sector sizes from 512 to 2,064 bytes/sector
Programmable sector reallocation scheme
Flawed sector reallocation at format time
Programmable auto write and read reallocation
Reallocation of defects on command (post format)
ECC maximum burst correction length of 240 bits with a guaranteed burst correction length of 233 bits.
Sealed head and disc assembly
No preventative maintenance or adjustment required
Dedicated head landing zone
Embedded servo design
Self diagnostics performed when power is applied to the drive
Zoned bit recording (ZBR)
Vertical, horizontal, or top down mounting
Dynamic spindle brake
4,096 kbyte data buffer (16,384 kbytes on LWV and LCV models)
Hot plug compatibility (Section 9.6.4.2 lists proper host connector needed) for LC and LCV model drives
Drive Self Test (DST)
Supports SCSI bus fairness
The Cheetah 36LP family has the following standard features: Media characteristics The media used on the drive has a diameter of approximately 3.3 inches (84 mm). The aluminum substrate is Performance Supports industry standard Ultra3 SCSI interface Reliability Compatibility This drive is compatible with any of our SCSI controllers UNFORMATTED CAPACITY (GB) ________________43.7
FORMATTED CAPACITY (GB) __________________36.7
AVERAGE SECTORS PER TRACK ________________423 rounded down
ACTUATOR TYPE ____________________________ROTARY VOICE COIL
TRACKS ___________________________________169,200
CYLINDERS ________________________________14,100 user
HEADS ______PHYSICAL______________________12
DISCS (3.0 in) ___________________________6
MEDIA TYPE _______________________________THIN FILM/GMR
RECORDING METHOD _________________________PRML 16/17 EPR4
INTERNAL TRANSFER RATE (mbits/sec)________280 to 427
INTERNAL FORMATTED TRANSFER RATE (MB/sec)_26.7 to 40.2
EXTERNAL TRANSFER RATE (mbyte/sec) _______40 Sync
Low Voltage Differential(LVD) _______80/160 Sync
SPINDLE SPEED (RPM) ______________________10,033
AVERAGE LATENCY (mSEC) ___________________2.99
BUFFER (/optional LWV and LCV) ___________4MB/16MB
Read Look-Ahead, Adaptive,
Multi-Segmented Cache
INTERFACE ________________________________Ultra-SCSI Wide
Low Voltage Differential __________Ultra3-SCSI Wide
ASA II, SCAM level 2 (1 default)
BYTES PER TRACK __________________________215,248
SECTORS PER DRIVE ________________________71,687,369
TPI (TRACKS PER INCH) ____________________18,145
BPI (PEAK KBITS PER INCH) ________________334
AVERAGE ACCESS (ms read/write)____________5.4/6.2
Drive level without controller overhead
SINGLE TRACK SEEK (ms read/write) ________0.8/1.1
MAX FULL SEEK (ms read/write) ____________11.2/11.9
MTBF (power-on hours) ____________________1,200,000
SHOCK (G's, 11/2/.5 ms):
operating (Read/Write) __________10
abnormal ________________________40
nonoperating ____________________75/200/100
ACOUSTICS (Bels typical, sound power) ____3.9
POWER DISSIPATION (watts/BTUs) Active ____/
Idle ______10.91/37.2
POWER REQUIREMENTS: +12V START-UP (amps) _2.2
+12V TYPICAL (amps) __0.58 idle
+5V START-UP (amps) __0.86
+5V TYPICAL (amps) ___0.79 idle
IDLE (watts) _________
LANDING ZONE (cyl) _______________________AUTO PARK
IBM AT DRIVE TYPE ________________________0 or NONE
Physical:
Height (inches/mm): 1.0/25.4
Width (inches/mm): 4.00/101.6
Depth (inches/mm): 5.75/146
Weight (lbs/kg): 1.3/0.589
|
There are no reviews yet.