Wohler AMP1-2SDA 2-Channel Stereo Monitor with 3G/HD/SD-SDI, AES, and Analog Inputs (1 RU)


Key Features
  • High-Quality Selectable Stereo Monitor
  • Balanced and Unbalanced Analog Inputs
  • Bright, Easy-to-Read Display
  • Two 26-Segment LED Meters
  • Stereo Phase Indicator
  • Headphone Output: 1/4″
  • Selectable Trim and Tone Controls
  • Shallow Chassis for Easy Installation
  • Upgrade Option: 8 Pairs of AES or Analog

9,499.00 د.إ

TheĀ AMP1-2SDAĀ fromĀ WohlerĀ is a 1 RU, 2-channel, 3G/HD/SD-SDI, AES, and analog audio monitor with a powerful audio amplifier to help overcome ambient noise. The unit provides instantaneous selection and monitoring of any available pair of audio from either a 16 channel SDI (with looped output), a single AES input pair, and either of the two pairs of analog inputs (balanced or unbalanced). Analog and AES outputs of the selected pair are included. Additional optional hardware input cards can provide up to 8 additional pairs of both Analog and/or AES on DB-25 inputs. The unit features adjustable volume and balance controls, while two on-board 26-segment level meters provide accurate audio level metering. You can visually and audibly monitor any selected audio pair. There is also a 4-digit, 14-segment display for setup and status display.

The AMP1-2SDA is small, low-cost, reliable, and simple to operate. It needs little configuration, as the unit ships already configured to the most commonly requested settings. However, should you need to change these settings, you can quickly and easily access the optional settings using the front panel controls and the Status Display.

  • High-fidelity Class-D amplifiers with Wohler quality sound
  • Quick selection of 3G/HD/SD-SDI, AES, and analog channel pairs to monitor through built-in speakers, headphones and analog outputs
  • Regenerated loop output of the SDI input
  • Balanced stereo analog outputs on XLR-M can be fixed, controlled by the Volume and Balance controls, or can be trimmed to various levels
  • Front panel 1/4ā€ headphone jack
  • Automatic frame rate detection and selection
  • Level metering for 2 (of 16) de-embedded 3G/HD/SD-SDI channels
  • High-resolution metering with 26 segments displayed
  • Level Meter Representation: Simultaneous average and PPM
  • Brightness control for displays, 2 levels
  • Permanent internal storage for all option settings
  • Easy software updates using a USB flash drive
  • Shallow chassis depth for easy installation in OB vehicles and consoles
  • IEC power input, 100 – 240 VAC ±10%, 50/60 Hz
  • Phase indicator for the selected stereo input channel pair
  • Simple uncluttered front panel controls
  • Selectable trim and tone controls
  • Option to add monitoring of additional 8 pairs of AES and/or Analog inputs
SKU: AMP1-2SDA Category: Tag:
Inputs
SDI
3G/HD/SD-SDI on BNC

AES
L/R on BNC
8 x L/R on DB25F (Optional)

Analog
Balanced L/R on XLR-F
Unbalanced L/R on RCA
Balanced 8 x L/R on 2 x DB25F (Optional)

Outputs
SDI: Regenerated on BNC
AES: L/R on BNC
Analog: Balanced L/R on XLR-M
Level Meters
2 x 26 segment LED
Level Meter Scale
AES
Status Display
4 x 14-segment green LED
Peak Acoustic Output
90 dB SPL (@ 2 feet)
Power Output
5 W RMS, 12 W peak (each side)
Frequency Response
Acoustic Frequency Response: 150 Hz to 16 kHz (±5 dB)
Analog Output Frequency Response: 40 Hz to 20 kHz (±1 dB)
Output Level
Analog Output Reference Level: -20 dBFS = +4 dBu (±1.0 dBu)
THD+N
Analog Output Distortion: <0.01% THD+N
Maximum Input Level
+28 dBu
Maximum Output Level
+28 dBu, +24 dB into 600 Ohms
Dynamic Range
A/D and D/A Dynamic Range: >96 dB
SDI Input Termination
75 Ohms unbalanced
AES/EBU Input Termination
75 Ohms unbalanced, switchable
110 Ohms balanced (optional module)
Input Impedance
Analog Input Impedance: 27 kOhms (minimum balanced)
Hum and Noise
Better than -68 dB below full output
Electrical Distortion
<0.05% at any level below limit threshold
SDI Formats Supported
SD: 29.97; 25

HD
720p: 23.98; 24; 25; 29.97; 30; 50; 59.94; 60
1035i: 29.97; 30
1080i: 25; 29.97; 30
1080sf: 23.98; 24; 25; 29.97; 30
1080p: 23.98; 24; 25; 29.97

3G
1080p: 50; 59.94; 60

Power
Power Requirements: 100 to 240 VAC ±10%, 50/60 Hz
Power Consumption: 60 W
Rack Space
1 RU
Dimensions
1.8 x 19.0 x 4.3″ / 44.5 x 483 x 108.0 mm
Weight
5.0 lb / 2.3 kg
Packaging Info
Package Weight
6.5 lb
Box Dimensions (LxWxH)
22.3 x 12.5 x 5.9″

Based on 0 reviews

0.0 overall
0
0
0
0
0

Be the first to review “Wohler AMP1-2SDA 2-Channel Stereo Monitor with 3G/HD/SD-SDI, AES, and Analog Inputs (1 RU)”

There are no reviews yet.