04 3550600 052 7036860

CE12804A-B02 Huawei CE12800 Series Data Center Switch

Add to Wishlist
Model: CE12804A-B02 Huawei CE12800 Series Data Center Switch
Detail:
CE12804 AC Bundle2 (AC Assembly Chassis,2*MPUA,5*SFU04B,3*PAC-2700WA)

131,399.00 د.إ

Add to Wishlist

CE12804A-B02 is CE12804 AC Bundle2 AC Assembly Chassis, 2*MPUA, 5*SFU04B, 3*PAC-2700WA.

Quick Specs

Figure 1 shows the appearance of CE12804A-B02.

CE12804A-B02 Appearance

Table 1 shows the Quick Specs.

Product Code CE12804A-B02
Switching Capacity
(Tbit/s)		 45/

258
Forwarding Rate
(Mpps)		 17,280
Service Slots 4
Switching Fabric
Module Slots		 6
LPU slots 4 (slot IDs: 01 to 04)
MPU slots 2 (slot IDs: 05 to 06)
CMU slots 2 (slot IDs: 07 to 08)
SFU slots 6 (slot IDs: 09 to 14)
Power slots 4 (slot IDs: PM1 to PM4)
Fan slots 9 (slot IDs: FAN1 to FAN9)

Product Details

Figure 2 shows the front panel of CE12804A-B02.

the front panel of CE12804A-B02

Note:

ā‘  Two CMUs ā‘” Cable management frame

NOTE:

Cable management frames are installed on the left and right sides of a chassis to route cables in each slot.
ā‘¢ Front ESD jack

NOTE:

When maintaining components at the front of a chassis, wear an ESD wrist strap and insert the other end of the ESD wrist strap into this ESD jack.

 ā‘£ Power modules
ā‘¤ Two MPUs

The CE12804 chassis uses the CE-MPUA.

 ā‘„ LPUs

CE12804 chassis: supports 4 LPUs.

*Ā CE12804A-B02 has only AC Assembly Chassis, 2*MPUA, 5*SFU04B and 3*PAC-2700WA, if you need other modules or cards, you must be purchased separately.

Figure 3 shows the back panel of CE12804A-B02.

the back panel of CE12804A-B02

ā‘  Serial number label ā‘” Rear ESD jack

 
ā‘¢ Ā Handle ā‘£ Power distribution unit
ā‘¤ MAC address label ā‘„ Fan modules
ā‘¦ SFU ā‘§ Two ground points for a dual-hole ground lug, with a yellow grounding label attached

* CE12804A-B02 has only AC Assembly Chassis, 2*MPUA, 5*SFU04B and 3*PAC-2700WA, if you need other modules or cards, you must be purchased separately.

SKU: CE12804A-B02 Category: Tags: , ,

CE12804A-B02 Specifications
Switching Capacity
(Tbit/s)		 45/
2581
Forwarding Rate
(Mpps)		 17,280
Service Slots 4
Switching Fabric
Module Slots		 6
Fabric Architecture Clos architecture, cell switching, VoQ, and distributed large buffer
Airflow Design Strict front-to-back
Device Virtualization Virtual System (VS)
Cluster Switch System (CSS)2
Super Virtual Fabric (SVF)3
Network Virtualization M-LAG
TRILL
VxLAN routing and bridging
EVPN
QinQ in VXLAN
VM Awareness Agile Controller
Network Convergence FCoE
DCBX, PFC, and ETS
Data Center Interconnect BGP-EVPN
Ethernet Virtual Network (EVN) for inter-DC Layer 2 network interconnections
Programmability OpenFlow
ENP programming
OPS programming
Puppet, Ansible, and OVSDB plug-ins released on open source websites
Linux container for open source and customization programming
Traffic Analysis NetStream
Hardware-based sFlow
VLAN Adding access, trunk, and hybrid interfaces to VLANs
Default VLAN
QinQ
MUX VLAN
GVRP
MAC Address Dynamic learning and aging of MAC addresses
Static, dynamic, and blackhole MAC address entries
Packet filtering based on source MAC addresses
MAC address limiting based on ports and VLANs
IP Routing IPv4 routing protocols, such as RIP, OSPF, IS-IS, and BGP
IPv6 routing protocols, such as RIPng, OSPFv3, ISISv6, and BGP4+
IP packet fragmentation and reassembling
IPv6 IPv6 over VXLAN
IPv6 over IPv4
IPv6 Neighbor Discovery (ND)
Path MTU Discovery (PMTU)
TCP6, ping IPv6, tracert IPv6, socket IPv6, UDP6, and Raw IP6
Multicast IGMP, PIM-SM, PIM-DM, MSDP, and MBGP
IGMP snooping
IGMP proxy
Fast leave of multicast member interfaces
Multicast traffic suppression
Multicast VLAN
MPLS Basic MPLS functions
MPLS VPN/VPLS/VPLS over GRE
Reliability Link Aggregation Control Protocol (LACP)
STP, RSTP, VBST, and MSTP
BPDU protection, root protection, and loop protection
Smart Link and multi-instance
Device Link Detection Protocol (DLDP)
Ethernet Ring Protection Switching (ERPS, G.8032)
Hardware-based Bi-directional Forwarding Detection (BFD)
VRRP, VRRP load balancing, and BFD for VRRP
BFD for BGP/IS-IS/OSPF/Static route
In-Service Software Upgrade (ISSU)
Segment Routing (SR)
QoS Traffic classification based on Layer 2, Layer 3, Layer 4, and priority information
Actions include ACL, CAR, and re-marking
Queue scheduling modes such as PQ, WFQ, and PQ + WRR
Congestion avoidance mechanisms, including WRED and tail drop
Traffic shaping
O&M IEEE 1588v2
Packet Conservation Algorithm for Internet (iPCA)
Dynamic Load Balancing (DLB)
Dynamic Packet Prioritization (DPP)
Network-wide path detection
Microsecond-level buffer detection
Configuration
and Maintenance		 Console, Telnet, and SSH terminals
Network management protocols, such as SNMPv1/v2c/v3
File upload and download through FTP and TFTP
BootROM upgrade and remote upgrade
Hot patches
User operation logs
Zero-Touch Provisioning (ZTP)
Security
and Management		 802.1x authentication
RADIUS and HWTACACS authentication for login users
Command line authority control based on user levels, preventing unauthorized users from using commands
Defense against MAC address attacks, broadcast storms, and heavy-traffic attacks
Ping and traceroute
Remote Network Monitoring (RMON)
Dimensions
(W x D x H, mm)		 442 x
813 x
486.15
(11 U)
Chassis Weight (empty) < 110 kg
(242 lb)
Operating Voltage AC: 90V to 290V
DC: -38.4V to -72V
HVDC: 240V
Max. Power Supply 6,000W

Based on 0 reviews

0.0 overall
0
0
0
0
0

Be the first to review “CE12804A-B02 Huawei CE12800 Series Data Center Switch”

There are no reviews yet.

Related products